Bodies & Trailers
Dump Bodies
Pup Trailer
Van Bodies
Platform Bodies
Expanding Side/Specialized Trailers
Dura Dump Hoist
Dura Dump Hoists are designed to lift your payload and your profits! They incorporate the finest engineering and design for long-lasting, trouble-free life.
Sizes
Specifications
18K
Features � Dependable smooth-lifting cycle designed to fit your payload requirements. � Trunnion-mounted cylinders require a shallow cylinder housing or can be mounted out in front of the body without any protrusion into the load area. � Wear-points are minimized with self lubricated bushings, resulting in reduced maintenance. � Low 9" mounting height. � Heavy-duty components and longitudinal design assure stability throughout the dumping cycle. � Heavy-duty body guides and safety prop. Pump Gear-type with built-in relief valve. Long-life, anti-friction bearings. Integral shaft and gear. Direct-mounted to PTO. � WTM series: 48 GPM @ 1800 RPMs � WFMS series: 21 GPM @ 1800 RPMs Cylinder Mounting Williamsen's cylinders are trunnion mounted and lift from a solid structural base at the lower front of the body. Base-lift series lifts through a tubular housing assembly covering the complete cylinder. Inverted-lift series lifts through brackets attached directly to body. Controls Heavy-duty, deluxe, lighted in-cab control tower, with detent position for hoist valve connected by heavy-duty cables sealed in grease and weatherproofed. WTM Series Rear Hinge Williamsen's hinge features a full-width cross shaft. The hinge assembly (formed from 3/8" hi-tensile steel, 13" deep and 38" wide) becomes the truck's rear cross member and, with the cross shaft, integrates both sides of the truck frame so it will work in tandem - providing greater stability during the dumping cycle. WFMS Series Full-steel sub-frame absorbs shock and twisting while in operation. It also provides greater stability while dumping. The hinge is built into the sub-frame and heavy-duty 1 1/2" diameter pins are used to minimize wear and provide strength. Oil Tank Mounted on side of truck frame for personal safety and convenience. Oil can be checked and serviced without lifting dump body. Front Lift Assembly Williamsen's cylinders lift from a solid base constructed of 1/2" x 5" x 5" tube with 1" thick ears with solid pin. Mounts across truck frame. *Specifications are subject to change without notice.